next up previous
Next: 6 SCA Implementation Up: Fast Indexing: Support for Previous: 4 File Operations

5 Index File Consistency

With the introduction of a separate index file to store the index table, we now have to maintain two files consistently.

Normally, when a file is created, the directory of that file is locked. We keep both the directory and the encoded data file locked when we update the index file. This way both the encoded data file and the index file are guaranteed to be written correctly.

We assume that encoded data files and index files will not become corrupt internally due to media failures. This situation is no worse than normal file systems where a random data corruption may not be possible to fix. However, we do concern ourselves with three potential problems with the index file: partially written file, a lost file, and trivial corruptions.

An index file could be partially written if the file system is full or the user ran out of quota. In the case where we were unable to write the complete index file, we simply remove it and log a warning message through syslog(3)--where the message could be passed on to a centralized logging facility that monitors and generates appropriate alerts. The absence of the index file on subsequent file accesses will trigger an in-kernel mechanism to recover the index file. That way the index file is not necessary for our system to function; it only aids in improving performance.

An index file could be lost if it was removed intentionally (say after a partial write) or unintentionally by a user directly from the lower file system. If the index file is lost or does not exist, we can no longer easily tell where encoded bytes were stored. In the worst case, without an index file, we have to decode the complete file to locate any arbitrary byte within. However, since the cost of decoding a complete file and regenerating an index table are nearly identical (see Section 7.6), we chose to regenerate the index table immediately if it does not exist, and then proceed as usual as the index file now exists.

We verify the validity of the index file when we use the index table. We check that all index entries are monotonically increasing, that it has the correct number of entries, file size matches the last entry, flags used are known, etc. The index file is regenerated if an inconsistency is detected. This helps our system to survive certain meta-data corruptions that could occur as a result of software bugs or direct editing of the index file.

We designed our system so that the index file can be recovered reliably in all cases. Four important pieces of information are needed to recover an index file given an encoded data file. These four are available in the kernel to the running file system:

  1. The SCA used.
  2. The page size of the system on which the encoded data file was created.
  3. Whether the file system used is 32-bit or 64-bit.
  4. Whether fast tails were used.

To recover an index file we read an input encoded data file and decode the bytes until we fill out one whole page of output data. We rely on the fact that the original data file was encoded in units of page size. The offset of the input data where we finished decoding onto one full page becomes the first entry in the index table. We continue reading input bytes and produce more full pages and more index table entries. If fast tails were used, then we read the size of the fast tail from the last two bytes of the encoded file, and we do not try to decode it since it was written unencoded.

If fast tails were not used and we reached the end of the input file, that last chunk of bytes may not decode to a whole output page. In that case, we know that was the end of the original file, and we mark the last page in the index table as a partial page. While we are decoding pages, we sum up the number of decoded bytes and fast tails, if any. The total is the original size of the data file, which we record in the index table. We now have all the information necessary to write the correct index file and we do so.

next up previous
Next: 6 SCA Implementation Up: Fast Indexing: Support for Previous: 4 File Operations
Erez Zadok 2001-10-06